Toshiba E-STUDIO2008A - 4.7.3 Discharge LED

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 90
4.7.3 Discharge LED
(1) Remove the drum cleaner unit.
( P. 4-88 "4.7.2 Drum cleaner unit")
(2) Release 1 latch and take off the discharge
LED unit [1].
Notes:
Be careful not to touch or scratch the drum
surface at this time.
Fig. 4-245
(3) Release the harness [2] from the harness
guide and pull out the discharge LED [3].
Notes:
The number of the discharge LEDs for
20ppm/25ppm/30ppm differs from that for
35ppm/45ppm/50ppm, therefore do not
install the LEDs in a wrong model.
Fig. 4-246
Fig. 4-247
20ppm/25ppm/30ppm
35ppm/45ppm/50ppm