Toshiba E-STUDIO2008A - 5.4.2 Output check

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 10
5.4.2 Output check
The status of the output signal can be checked.
<Operation procedure>
Procedure 1
Procedure 2
* To perform the fax line 2 modem test or CML test, press [F1] to switch the line mode. (By
pressing [F1], the line mode is switched between line1 and line 2.)
Procedure 3
Procedure 4
Procedure 5
* To perform the fax line 2 modem test or CML test, press [F1] to switch the line mode. (By
pressing [F1], the line mode is switched between line1 and line 2.)
* Return to the standby screen for code input by pressing [Clear].
Refer to the "Self-diagnostic code list" (separate document) for the codes available in the test mode 03.
[03]
[FS]
[POWER] OFF/ON
(Exit)
[START]
(Code)
Operation
ON
Stop
code
Operation
OFF
[START]
[03]
*1
[FS]
[POWER] OFF/ON
(Exit)
]RAELC[]TRATS[
Operation
One direction
Test mode
standby
(Code)
[03]
[FS]
[POWER]
OFF/ON
(Exit)
(Code)
[START] [START]
Operation
ON
Test mode
standby
[CLEAR]
Operation
OFF
[03]
[FS]
[POWER] OFF
[START]
(Code)
[03]
[FS]
*1
[START] [Digital keys]
[START]
[POWER] OFF/ON
(Exit)
(Code)
[START]