Toshiba E-STUDIO2008A - 11. FIRMWARE UPDATING; 11.1 Overview

11
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
FIRMWARE UPDATING
11 - 1
11. FIRMWARE UPDATING
11.1 Overview
When you want to update the firmware to the latest one or the equipment becomes inoperable due to
some defect in the firmware, updating can be performed as follows.
Equipment
Options
Notes:
• Written firmware varies depending on the kinds of the boards provided as service parts. For
updating, only the minimum firmware is installed on the system control PC board, logic PC board,
scanning section control PC board and FAX board. The latest version of the firmware at the time
of delivery is written on the RADF control PC board and finisher control PC board.
When any of above boards is replaced with a new one in the field, check the other firmware
version used and then update with a corresponding suitable version.
• "Can't fetch Ver." is displayed in the Installed Version field when the version of the installed
firmware cannot be acquired properly. If a normal power on is not performed after the firmware is
updated and the [ON/OFF] button is pressed while simultaneously holding down the [4] and [9]
buttons, "Can't fetch Ver." may be displayed on the control panel for some firmwares. A normal
power on must be performed.
Firmware Updating method
System firmware
USB device
Engine firmware
Scanner firmware
System software
PFC firmware
Model name Firmware Updating method
Reversing Automatic Document
Feeder (RADF)
(MR-3031)
RADF firmware USB device
Dual Scan Document Feeder
(DSDF)
(MR-4000)
DSDF firmware USB device
Finisher
(MJ-1042)
Finisher firmware USB device
Finisher
(MJ-1109)
Finisher firmware USB device
Finisher
(MJ-1110)
Finisher firmware USB device
Saddle stitcher firmware
Hole Punch Unit
(MJ-6105)
Hole punch unit firmware USB device
FAX Unit
(GD-1370)
FAX board firmware (Line1) USB device
FAX board firmware (Line2)