Toshiba E-STUDIO2008A - 6.14.3 B4-size recycled paper mode settings

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 78
6.14.3 B4-size recycled paper mode settings
Set this mode if the trailing edge of the paper gets caught by the exit section of the finisher while B4-
size recycled paper is used. This mode increases the paper exiting speed when the paper exits to the
movable tray in the sort mode, or to the stationary tray in the non-sort mode.
(1) Turn OFF the power of the equipment.
(2) Remove 1 screw and take off the board access cover.
(3) Set the SW1 on the Finisher control board as shown in the figures below.
Fig.6-82
Fig.6-83
(4) Turn ON the power of the equipment while [FUNCTION CLEAR] button and [START] button are
pressed simultaneously.
(5) Press [Button1] and [Button2] as described in the following table to set the B4-size recycled
paper mode. Press [Button1] and [Button2] on the control panel as below to set the B4-size
recycled paper mode.
Notes:
Be sure to press [Button1] and [Button2] the correct number of times.
Press [Button1] and [Button2] simultaneously to cancel the operation.
Fig.6-84
SW1
Access cover
ON
1 2 3 4
LED3 LED2 LED1
Button2Button1