Toshiba E-STUDIO2008A - 4.7.12 Temperature;humidity sensor (S19); 4.7.13 Toner motor (M4)

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 98
4.7.12 Temperature/humidity sensor (S19)
4.7.13 Toner motor (M4)
(1) Remove the rear cover.
 P. 4-6 "4.1.15 Rear cover"
(2) Release 1 latch [1] and remove the
temperature/humidity sensor [2].
Fig. 4-262
(3) Disconnect 1 connector from the
temperature/humidity sensor [2].
Fig. 4-263
(1) Remove the flywheel.
 P. 4-80 "4.5.36 Flywheel"
(2) Disconnect 1 connector [1] and remove 1
screw, and then take off the toner motor [2]
with the bracket.
Fig. 4-264