Toshiba E-STUDIO2008A - 4.10.10 Center heater lamp (LAMP1);side heater lamp (LAMP2)

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 131
4.10.10 Center heater lamp (LAMP1)/side heater lamp (LAMP2)
Notes:
• When installing, pay attention not to
deform the thermistor.
• When installing, make sure that the
center thermistor [5] and side thermistor
[6] are in contact with the fuser roller.
• When installing, make sure that the edge
thermistor [7] is in contact with the fuser
roller.
Fig. 4-354
Fig. 4-355
(1) Remove the front side cover.
 P. 4-123 "4.10.2 Front side cover"
(2) Remove the rear side cover.
 P. 4-123 "4.10.3 Rear side cover"
(3) Remove the fuser roller cover.
 P. 4-123 "4.10.4 Fuser roller cover"
(4) Remove 2 screws [1] and release the
harness [2] from the harness guide.
Fig. 4-356