7
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
PREVENTIVE MAINTENANCE (PM)
7 - 51
7.10 Maintenance Part List
The parts used for the maintenance of this equipment are as follows.
* “P-I” represents the page item in “e-STUDIO206L/256/306/356/456/506 Service Parts List” or “e-
STUDIO207L/257/307/357/457/507 Service Parts List”.
No.1-13, 15-18: Refer to “e-STUDIO206L/256/306/356/456/506 Service Parts List” or e-
STUDIO207L/257/307/357/457/507.
No.14: Refer to “MJ-1101 Service Parts List” or “MJ-1107 Service Parts List”.
No. Item Purpose
Parts list
<P-I>
1 Door switch jig Used to adjust high-voltage transformer. 101-1
2 Brush Cleaning inside of the equipment 101-2
3 Doctor sleeve jig Measuring the gap between the development sleeve
and the doctor blade
101-3
4 Wire holder jig Fixing the wire at the assembly of the carriage wire 101-5
5 Belt tension jig Adjusting the belt tension at the installation of the
scan motor
101-6
6 High-voltage transformer jig Used to adjust high-voltage transformer. 101-7
7 Drum bag Storing the drum 102-21
Harness jig Updating the converter PC board 21-3
8 Patting powder For photoconductive drum 101-17
9 Color test chart (TCC-2) For test print (A4/LT) 101-22
10 Color test chart (TCC-3) For test print (A3/LD) 101-23
11 Fuser unit fuse For fuser unit 101-18
To Next Page
Loading...
