Toshiba E-STUDIO2008A - 4.13.4 KD-1059 (Large Capacity Feeder)

4
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
DISASSEMBLY AND REPLACEMENT
4 - 177
4.13.4 KD-1059 (Large Capacity Feeder)
(1) Press the [Power] button on the control panel
to shut it down.
(2) Turn the main power switch of the equipment
off.
(3) Disconnect the power cable.
(4) Remove 1 screw and take off the cover.
Fig. 4-480
(5) Disconnect 2 connectors. Remove 1 screw
and take off the ground cable.
[1] Damp heater harness (JPD)
[2] Signal harness
Fig. 4-481
(6) Remove 3 screws and take off 2 fixing
brackets on the rear side.
Fig. 4-482
[2]
[1]