Toshiba E-STUDIO2008A - 4.8 Developer Unit; 4.8.1 Developer unit

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 102
4.8 Developer Unit
4.8.1 Developer unit
Notes:
Make sure to perform “05-2390” and take off the process unit before the developer material is
replaced.
(1) Take out the process unit.
( P. 4-87 "4.7.1 Process unit")
(2) Remove the harness cover [1] by sliding it
downward.
Fig. 4-274
(3) Disconnect 1 connector.
Fig. 4-275
(4) Disconnect 2 connectors.
Fig. 4-276