Toshiba E-STUDIO2008A - 8.2.2 Service call

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 16
8.2.2 Service call
Error code Classification Contents Troubleshooting
C010 Drive system
related service call
Main motor abnormality: The main motor is not rotating
normally.
P. 8-149
C040 Paper feeding
system related
service call
PFP motor abnormality: The PFP motor is not rotating
normally.
P. 8-150
C130 Upper drawer tray abnormality: The upper drawer tray
motor is not rotating or the upper drawer tray is not
moving normally.
P. 8-151
C140 Lower drawer tray abnormality: The lower drawer tray
motor is not rotating or the lower drawer tray is not
moving normally.
P. 8-151
C150 PFP upper drawer tray abnormality: The PFP upper
drawer tray motor is not rotating or the PFP upper drawer
tray is not moving normally.
P. 8-152
C160 PFP lower drawer tray abnormality: The PFP lower
drawer tray motor is not rotating or the PFP lower drawer
tray is not moving normally.
P. 8-152
C180 LCF tray-up motor abnormality: The LCF tray-up motor is
not rotating or the LCF tray is not moving normally.
P. 8-153
C1A0 LCF end fence motor abnormality: The LCF end fence
motor is not rotating or the LCF end fence is not moving
normally.
P. 8-154
C1B0 LCF transport motor abnormality: The LCF transport
motor is not rotating normally.
P. 8-155
C260 Scanning system
related service call
Peak detection error: Lighting of the exposure lamp
(white reference) is not detected when power is turned
ON.
P. 8-156
C261 Peak detection error (high-light intensity):
(e-STUDIO207L/257/307/357/457/507 only)
P. 8-158
C262 Peak detection error (communication error):
(e-STUDIO207L/257/307/357/457/507 only)
P. 8-159
C270 Carriage home position sensor not turning OFF within a
specified period of time: The carriage does not shift from
its home position in a specified period of time.
P. 8-159
C280 Carriage home position sensor not turning ON within a
specified period of time: The carriage does not reach to
its home position in a specified period of time.
P. 8-162
C290 Scanner fuse blowout: 24V power for the scanning
system is not supplied at the scanner warming-up after
power-ON.
P. 8-164
C3D0 Process related
service call
EPU board memory overwriting error: The overwriting of
the EPU board memory fails.
P. 8-166
C3D1 EPU board memory new parts detection error: The EPU
board detects the process unit as a new unit when the
equipment is started in the normal mode.
P. 8-166
C3D2 EPU board memory old parts detection error: The EPU
board cannot detect the new process unit when the
equipment is started in the EPU replacement mode ([7] +
[START]).
P. 8-167