Toshiba E-STUDIO2008A - 9.1.4 LGC board

9
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
REPLACEMENT OF PC BOARDS/HDD
9 - 5
9.1.4 LGC board
(4) Remove 2 screws and take off the ground
cable [3]. Remove the hard disk [4] from the
bracket.
Fig. 9-12
(1) Remove the rear cover.
 P. 4-6 "4.1.15 Rear cover"
(2) Disconnect 16 connectors and remove the
flat cable [2] connected to the LGC board [1].
Fig. 9-13
(3) Release the lock by pushing the actuators [3]
and remove 2 flat cables [4].
Fig. 9-14