Toshiba E-STUDIO2008A - 5.14 [74 HDD assist mode]; 5.14.1 Overview; 5.14.2 Operation procedure

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 44
5.14 [74 HDD assist mode]
5.14.1 Overview
This mode is available only when the security HDD (ADI-HDD) is mounted in the equipment. It enables
you to check the type of the mounted HDD, revert the ADI-HDD to the factory default or remove keys.
Functions of 74 HDD assist mode
• Checks the type (ADI or SATA) of the mounted HDD.
• Disposes of ADI-HDD data safely without any of leakage.
• Deletes image data when reusing a used ADI-HDD.
5.14.2 Operation procedure
(1) Perform [HS-74] by pressing the [74 HDD Assist mode] icon.
Then the type of the mounted HDD is checked and either of the following screens is displayed.
• When the security HDD is mounted
Fig.5-28
• When a normal HDD is mounted
Fig.5-29
HDD Assist Mode (4C)
System Firmware Version: XXXXXXCurrent HDD Type : ADI HDD
Select Menu
Cancel
Remove
Key
Revert
Factory Initial
Status HDD

HDD Assist Mode (4C)
System Firmware Version: XXXXXXCurrent HDD Type : SATA HDD
Select Menu
Cancel
Remove
Key
Revert
Factory Initial
Status HDD
