Toshiba E-STUDIO2008A - Page 288

e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 168
(7) Remove 1 screw and take off the cover.
Fig. 4-450
(8) Remove 1 screw and take off the ground
cable. Disconnect 2 connectors.
[1] Damp heater harness (JPD)
[2] Signal harness
Fig. 4-451
(9) Remove 6 screws and take off the rear
cover.
Fig. 4-452
(10) Remove 2 screws and take off the SYS
board cover.
Fig. 4-453
[1]
[2]