e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 170
(15) Connect 2 connectors. Install the ground
cable with 1 screw.
[1] Damp heater harness (JPD)
[2] Signal harness
Fig. 4-458
(16) Install the cover with 1 screw.
Fig. 4-459
(17) Remove 4 screws and take off 2 brackets.
Fig. 4-460
(18) Remove 2 screws and 1 washer.
Fig. 4-461
[1]
[2]
To Next Page
Loading...
