5
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SELF-DIAGNOSTIC MODE
5 - 13
Procedure 6
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
Procedure 7
* When the automatic adjustment ends abnormally, an error message is displayed.
* Return to standby screen by pressing the [CANCEL] or [CLEAR] button.
Procedure 10
Procedure 12
Procedure 17
* The automatic adjustment starts when 2 seconds have passed after the [START] button is pressed.
Notes:
The temperature control of the heat roller at the 05 adjustment mode is different from that at the
normal state. Therefore, a problem may occur in the fusing ability during the test copy at the 05
adjustment mode. In that case, turn the power ON normally and leave the equipment for approx.
3 minutes, and then restart the adjustment mode.
Refer to the "Self-diagnostic code list" (separate document) for the codes available in the [05
ADJUSTMENT MODE].
[05]
[FS]
[
START
]
[
Test cop]
[POWER]OFF/ON
(Exit)
[Digital key]
(Code)
[START]
*[CANCEL] or [CLEAR]
Automatic
adjustment
[05]
[FS]
[START]
[
Test copy]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[CLEAR]
(Corrects value)
[START][START]
*[CANCEL] or [CLEAR]
[CANCEL]
[OK]
Stores value
in RAM
Automatic
adjustment
[05]
[FS]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[START] [START][START]
[OK]
(Value unchangeable)
Value
displayed
[05]
[FS]
[
CLEAR
]
[
START
] (Ringing)
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[CANCEL]
[Digital key]
(Key in a value)
[CLEAR]
(Corrects value)
[OK]
(Stores value
in RAM)
[FS]
[Digital key]
(Code)
[START]
[UP]
or
[DOWN]
(Adjust a value)
Automatic
adjustment
()
[UP]
or
[DOWN]
(Adjust a value)
[OK]
or
[INTERRUPT]
Stores value
in RAM
[POWER]
OFF/ON
(Exit)
[FAX]
(Test copy)
[START]
[CANCEL] or [CLEAR]
[05]
To Next Page
Loading...
