6
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
SETTING / ADJUSTMENT
6 - 59
[B] Adjustment
If the pins cannot be fitted into the holes, perform the adjustment according to the following procedure.
(1) Remove the right-hand hinge screw at the
rear side.
Fig.6-51
(2) Loosen the left-hand hinge screw at the rear
side.
Fig.6-52
(3) Loosen the hinge screws at the front side.
Fig.6-53
MR-3028
To Next Page
Loading...
