e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 82
[EB60] Paper left on the transport path due to multiple feeding
[E360] Paper fed from the PFP lower drawer not reaching the PFP upper drawer feed sensor
Classification Error content
Paper transport jam The multiple feeding of preceding paper caused the misfeeding of
upcoming paper
Proce
dure
Check item Result Measure
Next
Step
1
Open the Automatic
duplexing unit. Is there
any paper in front of the
registration sensor?
Yes Remove the paper.
No
2
2
Is the registration sensor
working?
(Perform the input check
in the test mode: 03-
[FAX]OFF/[6]/[E])
Yes
3
No • Check if the connector CN316 on the LGC
board is disconnected.
• Check if the connector of the registration
sensor is disconnected.
• Check if the connector pins are
disconnected and the harnesses are open
circuited.
• Check if the conductor pattern on the LGC
board is short circuited or open circuited.
• Replace the registration sensor.
• Replace the LGC board.
3
Roller • Check the rollers. Replace them if they are
worn out.
Parts to be replaced Remark
Registration sensor
LGC board
Rollers on the transport path
Classification Error content
Paper transport jam Jam not reaching the PFP upper drawer feed sensor
Proce
dure
Check item Result Measure
Next
Step
1
Open the PFP side cover.
Is there any paper in front
of the PFP upper drawer
feed sensor?
Yes Remove the paper.
No
2
To Next Page
Loading...
