e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 136
[EAE0] Receiving time-out jam
Replace parts Remarks
Feeding sensor (S22)
Junction box paper detection sensor
(S26)
Transport path-2 (S27)
Transport path-3 (S28)
Ejecting roller (S29)
Interface PC board (I/F)
Saddle stitcher controller board
Finisher controller board
Classification Error content
Finisher jam
Receiving time-out jam
Proce
dure
Check item Result Measure
Next
Step
1
Is the finisher working? Yes Replace the finisher controller PC board.
No 2
2
Are the versions of the
Finisher, Saddle Stitch
Finisher and converter
firmware the latest?
Yes Download the firmware in the latest version.
No 3
3 • Check if the voltage (24V) is being supplied
to the finisher.
• Check the connection of the LGC board and
IPC board
• Check if the harness connecting the IPC
board and finisher I/F connector of the
equipment side is open circuited.
• Check if the harness connecting the I/F
connector of the finisher side and finisher
controller PC board is open circuited.
Parts to be replaced Remark
Finisher controller PC board
To Next Page
Loading...
