8
© 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A
ERROR CODE AND TROUBLESHOOTING
8 - 201
[CBB0]Rear saddle stapler home position error
MJ-1106/1108
[CBC0] Saddle Stitch Finisher side alignment motor (M15) abnormality
MJ-1106/1108
* You receive a [CBC0] error when the [EF15] error occurs three times in succession.
[CBC0] Saddle stitch alignment motor (M8) abnormality
MJ-1033
Classification Error item
Finisher related service call
Check item Measures
Rear saddle stapler clinch unit Harness check
Saddle control PC board (SDL) • Connector check (CN7)
• Board check
Replace parts Remarks
Rear saddle stapler clinch unit
Saddle control PC board
Classification Contents
Finisher related service call
Check Item Measure
Saddle Unit If there is mechanical problem when the jog is moved, fix the
mechanism.
Side alignment motor (M15) Harness check
Saddle control PC board (SDL) • Connector check (CN7)
• Board check
Replacement part Measure
Side alignment motor (M15)
Saddle control PC board (SDL)
Error Timing of detection
Saddle stitch alignment motor
Saddle stitch alignment plate home
position sensor
The turning OFF of the saddle stitch alignment plate home
position sensor (S20) is not detected in the specified time when
the saddle stitch alignment plate is moved from a point where
this sensor is turned ON to one point where this sensor is
turned OFF.
The turning ON of the saddle stitch alignment plate home
position sensor (S20) is not detected in the specified time when
the saddle stitch alignment plate is moved from a point where
this sensor is turned OFF to one point where this sensor is
turned ON.
Probable cause Checking and measures
Saddle stitch alignment motor (M8)
abnormality
Check if the electrical continuity of the coil is normal. If
electricity is not conducted, replace the motor.
To Next Page
Loading...
