e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS/HDD
9 - 30
[I] Backup license
Notes:
If "License SRAM to FROM" is performed by mistake, carry out the following procedure.
P. 9-35 "[ 1 ] Re-registration when the board is replaced"
(1) Performs FS-73.
(2) Press the [Key Backup/Restore].
(3) Press the [License] and then [Execute].
(4) Wait until the backup of the license is completed. "Success" is displayed.
(5) Restart the equipment after the backup is completed.
(6) Turn the power OFF.
[J] Initialize SRAM
(1) Performs FS-08.
(2) Initialize the SRAM error.
1.When “SRAM REQUIRES INITIALIZATION” is displayed on the LCD, check the destination
and then press the [START] Key.
If the destination is not correct, key in the correct one and then press the [START] Key.
2.After the confirmation message is displayed, press the [OK].
(3) Perform the initialization at the software version upgrade (FS-08-9030).
(4) Initialize the NIC information (FS-08-9083).
(5) Enter the serial number (FS-08-9601).
Key in the serial number on the label attached to the rear cover of the equipment, and then press
the [OK].
(6) Turn the power off.
To Next Page
Loading...
