Toshiba e-studio212 - CIS Unit (CIS)

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
SCANNER
6 - 21
6.7.7 CIS unit (CIS)
(4) Release 2 latches and take off the platen
sensor.
Fig. 6-25
(1) Take off the original glass.
 P.6-16 "6.7.1 Original glass"
(2) Move the CIS unit to the right most position.
Fig. 6-26
Notes:
• Be sure to hold the CIS unit drive belt-1 to
move the CIS unit.
• When the CIS unit is moved, be sure not
to touch the shaft as the silicon oil is
applied on it.
Fig. 6-27
Platen sensor
CIS unit
CIS unit drive belt-1