Toshiba e-studio212 - Paper Feed Controller PC Board (PFC)

e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 24
2.6.4 Paper feed controller PC board (PFC)
Note:
This paper feed controller PC board is optional for NAD, CND and MJD.
(3) Disconnect 2 connectors, remove 1 screw,
and then take off the fuse PC board by lifting
it up.
Fig. 2-28
(1) Take off the rear cover.
 P.2-21 "2.5.10 Rear cover"
(2) Disconnect 2 connectors, remove 4 screws,
and then take off the paper feed controller
PC board and mylar sheet.
Notes:
• If the ADU (optional) is installed,
disconnect 2 connectors of the ADU with
other connectors at the same time before
taking off the paper feed controller PC
board.
• If the PFP (optional) is installed,
disconnect 2 connectors of the PFP with
other connectors at the same time before
taking off the paper feed controller PC
board.
Fig. 2-29
Connector
Fuse PC board
Connector
(
PFP
)
Connector
(
ADU
)
Paper feed controller
PC board
Connector
Mylar