Toshiba e-studio212 - Switching Regulator Unit (PS)

2
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
OUTLINE OF THE MACHINE
2 - 25
2.6.5 Switching regulator unit (PS)
(1) Take off the left cover.
 P.2-18 "2.5.3 Left cover"
(2) Disconnect 15 connectors.
Note:
The number of connectors to be
disconnected is 15 when the following
options are installed.
A: Paper Feed Controller (GH-1060)
B: Fax Kit (GD-1220/1221)
Note:
Connect the connectors to the correct faston
terminals on the switching regulator board.
Connector Harness
F. Red - Black-thick
E. Blue - White-thick
D. White - Black-thin
C. White - Red-thin
B. White - Red-thick
A. White - White-thick
Fig. 2-30
Fig. 2-31
(3) Remove 2 screws, slide the switching
regulator unit with the whole case slightly to
the front, and then lift it up to take it off.
Fig. 2-32
A
B
F
E
D
C
B
A
Switching regulator unit