Toshiba e-studio212 - Bypass Pickup Clutch; Bypass Feed Clutch

e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
9 - 16
9.5.9 Bypass pickup clutch / Bypass feed clutch
(3) Release the harness from the harness clamp
and slide the pickup solenoid with the spring
upward to take it off.
Note:
When installing the bypass pickup solenoid,
be sure to place the spring between the arm
and the solenoid.
Fig. 9-24
(1) Take off the bypass unit.
 P.9-10 "9.5.1 Bypass unit"
(2) Remove 1 E-ring, 1 bushing and 2 screws.
Then take off the 1 bracket and 2 gears.
Fig. 9-25
(3) Take off the bypass pickup clutch with its
shaft.
Fig. 9-26
Bypass pickup solenoid
Spring
Gear
Gear
Bracket
Bushing
E-ring
Bypass pickup clutch