Toshiba e-studio212 - Registration Roller (Metal)

9
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
PAPER FEEDING SYSTEM
9 - 23
9.5.17 Registration roller (metal)
(3) Remove 2 washers, 1 E-ring, 1 gear, and 1
pin from the registration roller.
Fig. 9-46
(1) Take off the Process unit.
 P.10-9 "10.7.1 Process unit"
(2) Take off the transfer unit.
 P.10-18 "10.7.14 Transfer unit"
(3) Take off the registration clutch.
 P.9-20 "9.5.13 Registration clutch (CLT1)"
(4) Remove 1 clip, 1 bushing and then take off
the registration roller (metal) while sliding it to
the rear side.
Fig. 9-47
(5) Remove 1 bushing, 1 E-ring and then take
off 1 gear and 1 pin.
Fig. 9-48
Registration roller (rubber)
Pin
E-ring
Gear
Washer
Washer
Registration roller (metal)
Clip
Bushing
Registration roller (metal)
Pin
Bushing
Gear
E-ring