Toshiba e-studio212 - Exit Motor (M7): Option

12
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
FUSER / EXIT UNIT
12 - 23
12.6.11 Exit motor (M7): Option
(1) Take off the rear cover.
 P.2-21 "2.5.10 Rear cover"
(2) Disconnect 1 connector, remove 1 screw,
and then take off the exit motor with the
bracket while sliding it toward the right.
Fig. 12-37
(3) Release the harness from harness clamp,
remove 2 screws, and then takeoff the exit
motor.
Fig. 12-38
ConnectorBracket
Exit motor Screw
Bracket
Exit motor