Toshiba e-studio212 - Auto-Toner Sensor (S6); Drum Thermistor (THMS4); Guide Roller; Developer Sleeve

e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
11 - 14
11.6.4 Auto-toner sensor (S6)
11.6.5 Drum thermistor (THMS4)
11.6.6 Guide roller / Developer sleeve
(1) Remove the developer material.
 P.11-12 "11.6.2 Developer material"
(2) Place the developer unit upside down.
Disconnect 1 connector, release 1 latch, and
then rotate the auto toner sensor counter-
clockwise to take it off.
Fig. 11-14
(1) Remove the developer material.
 P.11-12 "11.6.2 Developer material"
(2) Disconnect 1 connector, remove 1 screw and
take off the drum thermistor.
Fig. 11-15
(1) Remove the developer material.
 P.11-12 "11.6.2 Developer material"
(2) Remove 2 screws and take off the recovered
toner supply unit.
Fig. 11-16
Connector
Auto toner sensor
Drum thermistor
Connector
Recovered toner
supply unit