Toshiba e-studio212 - Bypass Pickup Roller; Bypass Feed Roller; Bypass Paper Sensor (S8)

e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
9 - 14
9.5.5 Bypass pickup roller
9.5.6 Bypass feed roller
9.5.7 Bypass paper sensor (S8)
(1) Take off the bypass roller unit.
 P.9-12 "9.5.4 Bypass roller unit"
(2) Take off the bypass pickup roller and the
shaft.
Fig. 9-18
(1) Take off the bypass roller unit.
 P.9-12 "9.5.4 Bypass roller unit"
(2) Remove 1 clip. Then pull out the shaft.
(3) Take off the bypass feed roller.
Fig. 9-19
(1) Remove 1 screw on the bottom of the
equipment.
(2) Take off the bypass paper sensor with the
bracket.
Fig. 9-20
Shaft
Bypass pickup roller
Bypass feed roller
Shaft
Clip
Bracket