Toshiba e-studio212 - CIS Case

6
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
SCANNER
6 - 23
6.7.8 CIS case
Notes:
1. When installing the CIS unit, be sure to
pass the flat harness through the harness
holder of the CIS case.
2. Be sure to pull the flat harness so that it is
not warped.
Fig. 6-31
Fig. 6-32
(1) Take off the CIS unit.
 P.6-21 "6.7.7 CIS unit (CIS)"
(2) Remove 1 screw and take off the belt
stopper.
Note:
When installing the belt stopper, install it so
that the protrusion of the stopper fits in the V-
groove on the inside of the CIS unit drive
belt-1.
Fig. 6-33
Harness holder
Flat harness
Belt stopper
CIS unit
drive belt-1