9
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
PAPER FEEDING SYSTEM
9 - 7
9.4.2 Bypass tray
[A] Operation of drawer pickup roller
When the paper is set on the bypass tray, the bypass paper sensor (S8) detects it and judges that there
is paper on the bypass tray, and the bypass feeding is performed in preference to drawer feeding.
When the bypass pickup solenoid (SOL2) is turned ON, the driving force of the main motor (M3) is
transmitted to the bypass pickup clutch and bypass feed clutch. The bypass pickup roller is shifted
down by the drive from the bypass pickup clutch. And then, the bypass pickup roller, as well as the
bypass feed roller, is rotated by the drive from the bypass feed clutch to transport the paper on the
bypass tray to the bypass feed roller.
Fig. 9-4
Bypass pickup roller
Bypass pickup clutch
Bypass feed clutch
Bypass feed roller
Bypass separation pad
Bypass pickup solenoid
Bypass feed clutch
Bypass pickup clutch
To Next Page
Loading...
