Toshiba e-studio212 - Registration Clutch (CLT1); Pickup Solenoid (SOL1)

e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
9 - 20
9.5.13 Registration clutch (CLT1)
9.5.14 Pickup solenoid (SOL1)
(1) Take off the rear cover.
 P.2-21 "2.5.10 Rear cover"
(2) Remove 2 screws and take off registration
roller holder.
Note:
When installing the registration roller holder,
engage the arm of the registration clutch with
the rotation stopper of the registration roller
holder.
Fig. 9-37
(3) Release the harness from the harness
clamp, disconnect 1 connector and take off
the registration clutch.
Fig. 9-38
(1) Take off the rear cover.
 P.2-21 "2.5.10 Rear cover"
(2) Release the harness from the harness clamp
and disconnect 1 connector.
Fig. 9-39
Registration roller holder
Rotation stopper
Registration clutch
Connector
Harness clamp
Connector