Toshiba e-studio212 - Registration Roller (Rubber)

e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
9 - 22
9.5.16 Registration roller (rubber)
(4) Take off the cover-A, cover-B, spring and
flange.
Fig. 9-43
Note:
When assembling the drawer pickup clutch,
adjust the position of the hook of the spring
and the covers so that the stopper of the
cover-B and the center of the rib of the
cover-A are aligned.
Fig. 9-44
(1) Take off the transfer/separation charger.
 P.10-16 "10.7.12 Transfer/Separation
charger"
(2) Remove 1 clip and take off 1 gear and the
registration roller (rubber) while sliding them
to the front side.
Fig. 9-45
Flange
Spring
Cover-A
Cover-B
Hook
Rib
Slit
Stopper
Cover-A
Cover-B
Registration roller (rubber)
Clip