Toshiba e-studio212 - Disassembly and Replacement; Bypass Unit

e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
9 - 10
9.5 Disassembly and Replacement
9.5.1 Bypass unit
(1) Take off the ADU cover.
 P.2-20 "2.5.7 ADU cover"
(2) Remove 1 screw and take off the harness
cover.
Fig. 9-6
(3) Release the harness from the harness clamp
and disconnect 1 connectors.
Fig. 9-7
(4) Remove 2 screws, and take off the bypass
unit by lifting it up.
Note:
When installing the bypass unit, place the
guide behind the transfer unit.
Fig. 9-8
Screw
Harness cover
Connector
Bypass unitScrew
Screw
Guide