10
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
DRUM RELATED SECTION
10 - 21
10.7.17 Temperature/humidity sensor (S3)
(5) Remove 1 strap, release the harness from
the harness clamp, and take off the exhaust
fan with the duct.
Fig. 10-40
(6) Release the harness from the harness
clamp, remove the two-sided tape and take
off the exhaust fan.
Fig. 10-41
(1) Take off the left cover.
P.2-18 "2.5.3 Left cover"
(2) Disconnect 1 connector, remove 1 screw,
and then take off the temperature/humidity
sensor.
Fig. 10-42
Duct
Exhaust fan
Duct
Temperature/
Humidity sensor
To Next Page
Loading...
