e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
FUSER / EXIT UNIT
12 - 2
12.2 Configurations
Fuser / exit unit
Pressure roller unit Pressure roller PFA tube sponge roller (φ25)
Periodic replacement part
Exit sensor (S5)
Fuser roller unit Fuser roller Fluoro-plastic coated roller (φ30)
Periodic replacement part
Heater lamp (LAMP1, LAMP2) 564W+564W
Thermistor (THM1, 2, 3)
Fuser thermostat (THMO1) Non-contact type (170ºC)
Separation finger Periodic replacement part
Exit roller
Exit motor (M7) Stepping motor: option
To Next Page
Loading...
