4
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
GENERAL OPERATION
4 - 5
4.3 Detection of Abnormality
When something abnormal has occurred in the equipment, the symbols corresponding to the type of
abnormality are displayed.
4.3.1 Types of abnormality
1. Abnormality cleared without turning OFF the door switch
(A) Add paper
(B) Pick-up failure in bypass
2. Abnormality not cleared without turning OFF the door switch
(C) Misfeed in equipment
(D) Replace the toner cartridge
(E) Developer unit not installed properly
3. Abnormality not cleared without turning OFF the main switch
(F) Call for service
To Next Page
Loading...
