e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
DEVELOPMENT SYSTEM
11 - 16
(7) Disconnect 2 connectors, remove 3 screws
and take off the bracket.
Fig. 11-21
(8) Remove 1 E-ring and take off the guide roller
on the front side.
Fig. 11-22
(9) Remove 1 screw and the gear.
Fig. 11-23
(10) Remove 3 screws. Take off 1 bearing and the
bracket.
Fig. 11-24
Connector
Bracket
Guide roller
E-ring
Gear
Bearing
Bracket
To Next Page
Loading...
