Toshiba e-studio212 - Page 239

13
© 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO182/212/242
AUTOMATIC DUPLEXING UNIT (ADU) (OPTION: MD-0103)
13 - 11
13.6 Disassembly and Replacement
13.6.1 Automatic Duplexing Unit (ADU)
(1) Take off the right rear cover.
 P.2-21 "2.5.9 Right rear cover"
(2) Remove 1 screw and 1 ground wire.
(3) Disconnect 1 connector.
Fig. 13-7
(4) Open the transfer unit and release the ADU
stopper.
(5) Take off the ADU cover while sliding it toward
the right.
Fig. 13-8
(6) Remove 4 screws and take off the ADU.
Note:
When installing the ADU, be sure to put the
ADU stopper on the rear side through the
rear slit of the ADU.
Fig. 13-9
Ground wire
Connector
ADU stopper
Slit ADU stopper
ADU