e-STUDIO182/212/242 © 2009 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
2 - 2
E5 Bypass tray
F1 Needle electrode
F2 Main charger
F3 Main charger grid
F4 Toner cartridge
G1 Transfer charger wire
G2 Separation charger wire
G3 Transfer guide roller
H1 Drum
H2 Discharge LED
H3 Drum cleaning blade
H4 Recovery blade
H5 Drum separation finger
I1 Developer sleeve (Magnetic roller)
I2 Mixer-1
I3 Mixer-2
I4 Mixer-3
I5 Doctor blade
I6 Auto-toner sensor S6
I7 Toner recovery auger
I8 Toner recycle auger
I9 Drum thermistor THMS4
I10 Drum damp heater DH3
I11 Drum damp heater thermostat THMO3
J1 Fuser roller
J2 Pressure roller
J3 Fuser roller separation finger
J4 Center heater lamp LAMP1
J5 Side heater lamp LAMP2
J6 Center/Side/Edge thermistor THMS1/2/3
J7 Fuser thermostat THMO1
J8 Exit roller
J9 Exit sensor S5
K1 Front cover opening/closing switch SW4
K2 Front cover opening/closing interlock switch SW3
K3 Temperature/humidity sensor S3
K4 Switching regulator
K5 ADU cover opening/closing interlock switch SW2
L1 ADU upper transport roller
L2 ADU lower transport roller
L3 ADU paper guide
To Next Page
Loading...
