e-STUDIO2008A/2508A/3008A/3508A/4508A/5008A © 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING / ADJUSTMENT
6 - 18
[D] Reproduction ratio adjustment of the secondary scanning direction
<Procedure>
(1) Performs FS-05. (05 Adjustment Mode)
(2) Place a ruler on the original glass with its leading edge pushed against the original scale on the
left.
(3) Press [TEST COPY] [START] to make a copy at the mode of A3 (LD), 100% and the lower
drawer (Refer to *).
(4) Measure the distance C from 200 mm to 400 mm of the copied image of the ruler.
(5) Check if the distance C is within the range of 200±0.5 mm.
(6) If not, use the following procedure to change values and repeat steps (3) to (5) above.
FS-05 Key in the code [3032] [START]
(Key in a value (acceptable values: 63 to 193))
Press the [OK] button (stored in memory).
(“100% A” is displayed.)
* The smaller the adjustment value is, the lower the reproduction ratio becomes. (approx.
0.018%/step)
Fig.6-14
200 250 300 350 40050 100 150
C
Feeding direction
Copied image of the ruler
To Next Page
Loading...
