e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
PAPER FEEDING SYSTEM
10 - 12
[A-4] Bypass feed upper cover
Note:
Install the bracket so that its pointer is placed
at the same position as before.
Fig. 10-16
(4) Disconnect 1 connector, remove 1 screw and
take off the SFB board.
Fig. 10-17
(1) Take off the bypass unit ( P. 1 0 - 9 " [ A - 1 ]
Bypass unit").
(2) Remove 1 screw and slide the bypass feed
upper cover to take it off.
Fig. 10-18
Pointer
SFB board
Bypass feed upper cover
To Next Page
Loading...
