e-STUDIO281c/351c/451c © 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TRANSFER UNIT
14 - 16
[J] 2nd transfer unit
(5) Remove 1 clip, 1 collar (with bearing), 1
washer, 1 holder and 1 bushing (with bear-
ing) from the rear side of the 2nd transfer
roller.
Note:
A spring is fit in the holder. When the roller is
reassembled, make sure that the spring is
not installed incorrectly or deformed.
Fig. 14-27
(1) Take off the right front hinge cover
( P.2-28 "[I] Right front hinge cover").
(2) Remove 2 screws and take off the hinge pin.
Fig. 14-28
(3) Open the 2nd transfer unit.
(4) Disconnect 1 connector and release the har-
ness clamp.
(5) Remove 3 screws and take off the 2nd trans-
fer gear unit.
Fig. 14-29
Clip
Collar
Holder
Bushing
2nd transfer roller
Washer
Hinge pin
Gear unit
To Next Page
Loading...
