Toshiba GX9 - Page 266

254 GX9 ASD Installation and Operation Manual
Speed Limit (torque=0) Center Value, 154
Speed Limit (torque=0) Recovery Time, 154
Speed Loop Integral Gain, 146
Speed Loop Parameter Ratio, 146
Speed Loop Proportional Gain, 146
Speed Reach Detection Band, 84
Speed Reach Frequency, 84
ST, 20
ST Signal Selection, 85
ST terminal, 21
ST1, 15, 16
Stall, 51
Stall Cooperation Gain at Field Weakening Zone, 160
Stall Prevention Level, 184
Standard Mode Selection, 45
Start and Stop Points, 44
Start Frequency, 123
Startup and Test, 29
Startup Wizard, 15, 60
Startup Wizard Requirements, 62
Stop-Reset Key, 34
Supply Voltage Correction, 133
Suppression of Inrush Current Timing, 186
SW1, 24
SW2, 24
Switching Frequency Between Current and Voltage
Control, 161
Switching Load Torque During Forward-Run, 139
Switching Load Torque During Reverse-Run, 139
Synchronized Torque Bias Input Selection, 152
System Grounding, 19
System Integration Precautions, 8
System Operation, 60
T
T/L3, 17
Tension Torque Bias Input Selection (Torque Control),
152
Terminal, 47
Torque, 41, 52
Torque Boost Adjustment, 192
Torque Command Filter, 151
Torque Command Mode Selection, 154
Torque Command Selection, 151
Torque Control, 53
Torque Current, 42
Torque Limit Mode, 156
Torque Limit Mode (Speed Dependent), 157
Torque Limit Settings, 53
Torque Reference, 41
Torque Speed Limiting, 53
Transducer Setup, 44
Trip Code, 42
Trip History, 233
Trip Information, 233
trip records are retained, 233
Trip Settings, 52
Trouble Shooting, 223
TTL I/O, 26
Type Reset, 78
Typeform Error, 230
U
U/T1, 17
UC, 227
Under-Voltage (Trip Alarm) Detection Time, 190
Under-Voltage Trip Selection, 189
Under-Voltage/Ridethrough, 51
unstable VLP operation, 162
unstable VLP Technology operation, 161
UP/DOWN Frequency Disposition at Power Down, 88
UP/DOWN Frequency Function, 88
UP1, 232
UP2, 232
U-Phase Over-Current, 231
Upper Limit Frequency, 62
Upper Limit Frequency Adjustment, 192
Upper-Limit Frequency, 79
User Notification Codes, 224
Using the LCD Screen, 35
Utilities, 45
V
V/f Adjustment, 58
V/f Adjustment Coefficient, 102
V/f Five Point Setting, 57
V/f Five-Point 1 Frequency, 102
V/f Five-Point 1 Voltage, 103
V/f Five-Point 2 Frequency, 103
V/f Five-Point 2 Voltage, 103
V/f Five-Point 3 Frequency, 104
V/f Five-Point 3 Voltage, 104
V/f Five-Point 4 Frequency, 104
V/f Five-Point 4 Voltage, 104
V/f Five-Point 5 Frequency, 104
V/f Five-Point 5 Voltage, 105
V/f Pattern, 80
V/T2, 17
Vector Motor Model, 55, 56
VI, 20
VI terminal, 22
VI/II, 42