158
Figure 10-7 DSCP Priority
The following entries are displayed on this screen:
DSCP Priority Config
Enable/Disable DSCP Priority.
Priority Level
DSCP: Indicates the priority determined by the DSCP
region of IP
datagram. It ranges from 0 to 63.
Priority Level:
Indicates the 802.1P priority the packets with tag are mapped
to. The priorities are labeled as CoS0 ~ CoS7.
Note:
To complete QoS function configuration, you have to go to the Schedule Mode page to select
a schedule mode after the configuration is finished on this page.
Configuration Procedure:
1
Configure the mapping relation
between the DSCP priority and
Required. On QoS→DiffServ→DSCP Priority page,
enable DSCP Priority and configure the mapping
relation between the DSCP priority and CoS.
To Next Page
Loading...
