TP-Link T2500G-10TS - Page 34

24
The following entries are displayed on this screen:

Global Config
IPv6:
Enable/Disable IPv6 function globally on the Switch.

Link-local Address Config
Config Mode: Select the link-local address configuration mode.
 Manual:
When this option is selected, you should assign a
link-local address manually.
 Auto:
When this option is selected, the switch will generate a
link-local address automatically.
Link-local Address:
Enter a link-local address.
Status: Displays the status of the link-local address.
 Normal: Indicates that the link-local address is normal.
 Try: Indicates that the link-
local address may be newly
configured
 Repeat: Indicates that the link-local addr
ess is duplicate. It is
illegal to access the switch using the IPv6 address (
including
link-local and global address).

Global Address Autoconfig via RA Message
Enable global address
auto configuration via
RA message:
When this option is enabled, the switc
h automatically configures
a global address and other information according to the address
prefix and other configuration parameters from the received
RA
(Router Advertisement) message.

Global Address Autoconfig via DHCPv6 Server
Enable Global
Address Aut
oconfig
via DHCPv6 Server:
When this option is enabled, the system will try to obtain the
global address from the DHCPv6 Server.

Add a global address manually
Address Format:
You can select the global address format according to your
requirements.
 EUI-64:
Indicates that you only need to specify an address
prefix, and then the system will create a global address
automatically.
 Not EUI-64:
Indicates that you have to specify an intact
global address.
Global Address: When selecting the mode of EUI-64, please
input the address
prefix here, otherwise, please input an intact IPv6 address here.