TP-Link T2500G-10TS - Page 64

54
Choose the menu Switching→LAG→LACP Config to load the following page.
Figure 5-10 LACP Config
The following entries are displayed on this screen:

Global Config
System Priority:
Specify the system priority for the switch. The system prio
rity and
MAC address constitute the system identification (ID). A lower
system priority value indicates a higher system priority. When
exchanging information between systems, the system with higher
priority determines which link aggregation a link belongs
to, and the
system with lower priority adds the proper links to the link
aggregation according to the selection of its partner.

LACP Config
Port Select
: Click the Select button to quick-select the corresponding port
based on the port number you entered.
Select:
Select the desired port for LACP configuration. It is multi-optional.
Port:
Displays the port number.
Admin Key
: Specify an Admin Key for the port. The member ports in a dynamic
aggregation group must have the same Admin Key.
Port Priority
: Spe
cify a Port Priority for the port. This value determines the
priority of the port to be selected as the dynamic aggregation
group member. The port with smaller Port Priority will be
considered as the preferred one. If the two port priorities are
equal; the port with smaller port number is preferred.