31
Chapter 2 Configure Your Network Camera
• When Plug and Play is disabled, enter the password manually in the pop-up window to verify
it. Click Add.
2. 1. 3 Add Cameras Manually
If the devices cannot be automatically found by the NVR, you can add cameras manually using its
information. Follow the steps below to finish the configuration.
1. Right click on the Live View screen and click Add Camera in the pop-up Main Menu. Alternatively,
right click on the screen and click Settings in the pop-up Main Menu, then go to Camera > Device
Access > Add Device.
2. Click Add Manually.
To Next Page
Loading...
