32
Chapter 2 Configure Your Network Camera
3. Enter the information of the camera to add it. For VIGI security camera, enter the IP address and
password. Click Add.
IP Address The IP address of the camera.
Control Protocol
Select a protocol that your camera supports. The global protocol that
allows surveillance and security devices from different manufacturers
to operate together seamlessly.
Transfer Protocol
TCP(Transfer Control Protocol) that provides reliable, ordered delivery
of a stream of bytes from one device to another device.
Management Port
The management port to configure, maintain, and support a network
device.
Username The username of the camera.
Password The password of the camera.
2. 1. 4 Modify IP Addresses of Cameras
To avoid IP conflict and make sure your cameras are in the same subnet, you can modify the IP addresses
manually. Follow the steps below to finish the configuration.
1. Right click on the Live View screen and click Add Camera in the pop-up Main Menu. Alternatively,
right click on the Live View screen and click Settings in the pop-up Main Menu, then go to Camera
> Device Access > Add Device.
To Next Page
Loading...
