138
2. Inspect the tires for damage, wear, or punctures.
NOTE: Be sure all tires are the specified size and
have identical tread pattern.
NOTE: If pulling is noted, measure the circumfer-
ence of the front and rear tires on the pulling side.
Compare the measurements with the tires on the
opposite side. If pulling is noted during braking only,
check and adjust the brakes as necessary and recheck
operation (see Periodic Maintenance/Tune-up).
Troubleshooting
! WARNING
Do not operate the ATV if tire damage exists.
Problem: Suspension too soft
Condition Remedy
1. Spring(s) weak
2. Shock absorber damaged
3. Shock absorber preload too low
1. Replace spring(s)
2. Replace shock absorber
3. Adjust shock absorber preload
Problem: Suspension too stiff
Condition Remedy
1. A-arm-related bushings worn
2. Shock absorber preload too high
1. Replace bushing
2. Adjust shock absorber preload
Problem: Suspension noisy
Condition Remedy
1. Cap screws (suspension system) loose
2. A-arm-related bushings worn
1. Tighten cap screws
2. Replace bushings
Problem: Rear wheel oscillation
Condition Remedy
1. Rear wheel hub bearings worn — loose
2. Tires defective — incorrect
3. Wheel rim distorted
4. Wheel hub cap screws loose
5. Auxiliary brake adjusted incorrectly
6. Rear suspension arm-related bushing worn
7. Rear shock absorber damaged
8. Rear suspension arm nut loose
1. Replace bearings
2. Replace tires
3. Replace rim
4. Tighten cap screws
5. Adjust brake
6. Replace bushing
7. Replace shock absorber
8. Tighten nut
Problem: Vehicle pulling or steering erratic
Condition Remedy
1. Vehicle steering is erratic on dry, level surface
2. Vehicle pulls left or right on dry, level surface
1. Check front wheel alignment and adjust if necessary (see
Steering/Body/Controls)
2. Check air pressure in tires and adjust to specifications
To Next Page
Loading...
