EasyManua.ls Logo

Tracker 600 - Electrical System

Tracker 600
140 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
76
Troubleshooting
NOTE: In all scenarios, perform a TPS/ISC reset first and check fuel pressure, which should be 3 bar or
43.5 psi.
Problem: Starting impaired
Condition Remedy
1. Battery discharged or defective
2. Gas contaminated
3. Air filter/housing contaminated
4. Ambient temperature below -20° F (-29° C)
(coldest temperature at which engine will start)
1. Test, charge, and/or replace battery
2. Drain gas tank and fill with clean/fresh regular 87 octane
E10 fuel
3. Clean or replace air filter/housing
4. Use a jump pack to start engine
Problem: Idling or low speed impaired
Condition Remedy
1. Gas contaminated
2. TPS out of adjustment
3. Air filter/housing contaminated
4. ISC malfunction
1. Drain gas tank and fill with clean/fresh regular 87 octane
E10 fuel
2. Adjust TPS
3. Clean or replace air filter/housing
4. Inspect/replace ISC
Problem: Medium or high speed impaired
Condition Remedy
1. Gas contaminated
2. Air filter/housing contaminated
3. Exhaust system/spark arrestor debris and catalyst damage
1. Drain gas tank and fill with clean gas
2. Clean or replace air filter/housing
3. Clean exhaust system and spark arrestor. Inspect catalyst
with a borescope and replace if damaged.

Table of Contents

Related product manuals